Vulnerabilities

Vulnerability · CVE-2026-74686

In the Linux kernel, the following vulnerability has been resolved: rqspinlock: Reset tail when preserving queue on deadlock Currently, the destruction of the waiter q…

Published Aug 22, 2026 · catalog updated Oct 14, 2026 · the affected product

Check if you run it

No confirmed exploitation is on record for CVE-2026-74686. EPSS is 0.24%. Act only if a listed version of the affected product is installed.

Severity

Unknown—

Known exploitation

Not in CISA/VulnCheck KEV

EPSS

0.24%

Remediation

Not established

Affected products

See sources for product scope

In the Linux kernel, the following vulnerability has been resolved: rqspinlock: Reset tail when preserving queue on deadlock Currently, the destruction of the waiter queue is suppressed for rqspinlock in cases where a deadlock is detected. Deadlock checks happen relatively frequently (on entry for AA, within 1ms for ABBA), and waiter threads may not be involved in locking scenarios involving deadlocks. Thus, it is useful to not flush the queue and let other waiters take a stab at acquiring the lock after we detect a deadlock and exit. However, we need to follow the same logic as what we did previously for the waitq_timeout label: reset the tail, and if we cannot, signal the next waiter appropriately. In case of deadlocks, this signal would just mark the MCS node as unlocked, and in case of timeouts, it would signal RES_TIMEOUT_VAL. The difference thus is in the value propagated, which decides whether the queue remains active or gets flushed. Not doing the tail reset, and waiting for the next waiter can lead to cases where we are the final waiter, and thus no next waiter arrives, leading to intermittent stalls in this path. Once the next waiter does join, we will be unblocked. In the theoretical case when the next waiter never joins, we risk stalling indefinitely. This can only happen for ABBA deadlocks, since entry into the wait queue is guarded with AA checks. A precise sequence of executions leading up to this scenario can be: CPU 0 holds lock A. CPU 1 holds lock B. CPU 2 attempts lock B, becomes the pending waiter for B. CPU 0 attempts lock B. B has locked+pending bits set, thus CPU 0 queues. CPU 1 attempts lock A. CPU 0 detects an ABBA deadlock. Once deadlock detection happens for CPU 0, it will sit waiting for the next waiter in the queue to populate node->next, which will experience delays until such a waiter arrives. Fix this by adjusting the logic for the check for deadlocks preceding the waitq_timeout label. It would make sense to consolidate code for both

No affected version ranges are stored yet. Use the vendor advisory before you decide this record does not apply.