Vulnerabilities

Vulnerability · CVE-2026-74691

In the Linux kernel, the following vulnerability has been resolved: net: thunderbolt: Tear down DMA paths before stopping the rings tbnet_tear_down() stops both rings…

Published Aug 22, 2026 · catalog updated Oct 14, 2026 · the affected product

Check if you run it

No confirmed exploitation is on record for CVE-2026-74691. EPSS is 0.26%. Act only if a listed version of the affected product is installed.

Severity

High8.8

Known exploitation

Not in CISA/VulnCheck KEV

EPSS

0.26%

Remediation

Not established

Affected products

See sources for product scope

In the Linux kernel, the following vulnerability has been resolved: net: thunderbolt: Tear down DMA paths before stopping the rings tbnet_tear_down() stops both rings and frees their frame buffers before calling tb_xdomain_disable_paths(). tb_ring_stop() zeroes the ring's descriptor base and tbnet_free_buffers() unmaps and frees the pages the frames sit in, so by the time __tb_path_deactivate_hop() polls the hop's 'pending' bit, anything still in flight has nowhere to drain to. The teardown sequence has been in this order since the driver was added. The setup path has not: commit ff7cd07f3064 ("net: thunderbolt: Enable DMA paths only after rings are enabled") moved the path enable to the end of tbnet_connected_work() and documented why: /* Both logins successful so enable the rings, high-speed DMA * paths and start the network device queue. * * Note we enable the DMA paths last to make sure we have primed * the Rx ring before any incoming packets are allowed to * arrive. */ Teardown was never updated to match, so the rings and the paths now come down in the same order they go up instead of in reverse. On an ASMedia ASM4242 host router the 'pending' bit then never clears: every teardown burns the full 500 ms timeout and __tb_path_deactivate_hop() returns -ETIMEDOUT. Raising the timeout to 5 s does not help, so the hop is not slow to drain, it never drains at all. The failure is invisible above the thunderbolt core. __tb_path_deactivate_hops() is void and only calls tb_port_warn(); tb_path_deactivate(), tb_tunnel_deactivate() and __tb_disconnect_xdomain_paths() are void as well, and tb_disconnect_xdomain_paths() ends in an unconditional "return 0". So tb_xdomain_disable_paths() reports success and the netdev_warn() below it never fires. Repeated teardowns eventually take the XDomain control channel down, after which the peer node is gone and only a power cycle brings the controller back. Deactivating the paths first fixes it. Measured with kretprobes on a stock v6.17

No affected version ranges are stored yet. Use the vendor advisory before you decide this record does not apply.